Considerations when replenishing goods in vending machines

Writer： Zhongda vending machines Time：2022-10-22 16:46 Browse：℃

Considerations when replenishing goods in vending machines

When the vending machine replenishes its stock, the vending machine needs to carefully arrange its position according to the characteristics and features of the goods. When unmanned vending machines run out of stock, the first is that it affects profits and the second is that it reduces consumer stickiness. So what are the steps that need to be taken when the vending machine is replenished?

Firstly, use the key to open the vending machine. When opening the door, please note the glass door and the replenishment line for the goods, and place the prepared goods next to it. The door of the vending machine does not need to be opened too far, then press the movable button under the vending machine’s goods aisle cabinet, then slowly pull out the layer of goods and place it in a certain position to place the whole layer of goods.

Pay attention to the heavier bottles and cans packed on the bottom shelf of the vending machine. After replenishing the goods, gently push the containers in and then attach them with the safety bolts below, push them into the top and then snap them into place. Then locate the set button on the underside of the chassis and set it to full cargo status. Please note that it is important to set it after all items have been fully replenished. Finally, lock the vending machine to complete the replenishment. The restocking of the vending machine requires the following points to be noted.

1.Different sizes of products are suitable for placement in different sizes of aisles. If you are not sure which product you should place, use a ruler to measure the diameter and pitch of the spring and then compare the outer packaging of the product. The easiest way to check if a product is the right size is to place it in the spring aisle (the product must be in a fixed package), if it is not too tight and does not fall into the gap around the spring, then it is the right size.

2.When selling aerated carbonated drinks) should be placed as low as possible in the aisle, otherwise it is likely that the liquid inside the drink will spurt out when the customer opens it, thus affecting the customer’s buying experience.
<

3.If there are cans in your drinks, they should be placed in the aisle on a flat track to reduce the jamming rate. Because rows of cans travel in the goods aisle, it has much greater frictional resistance than plastic bottle packaging and is easy to k. Placing them in the flat bottom track can effectively reduce goods jams.

4.When placing bottles of beverages, please try to place the bottle cap downwards, which can effectively solve the embarrassing situation of not being able to take out the bottle easily when standing up after dropping it.

5.When placing products, please do not tilt the top end of the product outwards (you can stand upright or tilt inwards), this can effectively reduce the phenomenon of jammed goods caused by the top of the product.


6.Similar goods should be placed in the same spring loaded goods aisle, preferably with a full load each time. If insufficient goods are replenished, the innermost position should be left empty and no space should be left at the front of the freight aisle.

By using the correct method of replenishing goods, you can greatly reduce the rate at which vending machines get stuck during use and also allow consumers to enjoy a better shopping experience and increase their own sales.